Drawing Views (301)Time: 1.5
hour
Prerequisite: A working knowledge of part mode.
Detailed Drawings (302)Time: 45
minutes
Prerequisite: A working knowledge of part mode.
|
||
| Drawing Views (301) Time: 1.5
hour |
Description: This session
is intended as an introduction into drawing mode. It covers the creation of drawing
views including General, Projection, Auxiliary, Detailed, and
Revolved views. Full, Half, Broken, Partial,
Default Scale vs. Custom Scale, and Cross-Sectional views are also discussed in
detail. This module was pulled from the Basic Design course. Prerequisite: A working knowledge of part mode. |
| Detailed Drawings (302) Time: 45
minutes |
Description: After
attending a basic Pro/E course, some users still have a tendency to create dimensions
rather than show dimensions. In this session, the concept of 'driving' dimensions
versus 'driven' dimensions will be re-introduced. This module was pulled from the
Basic Design course. Prerequisite: A working knowledge of part mode. |
